Harbour directory

Thames Richmond boat Co. boat

Listed by Stephen T ·

Specifications

Boat Length
28" (71.12 cm)
Boat Weight
203g (7 oz)
Motor Type
Brushed
Drive Type
Direct
Props
Single
Max Amps
267A
Battery Type
LiFe
Battery mAh
288 mAh
Prop Type
314
Prop Size
330mm

Photos

About this boat

Aquired this boat some time ago I take it its some form of kit deck fitings have the look of a home made one 7.4 volt
I have since found out in the late 1950s Richmond boats made models of there actual Cabin crusiers for there customers children 24 was made in all so in every thing a bit of history boat story comes out

Comments

  1. ChrisFBronze
    Vice Admiral
    That's OK as long as you don't use it very often and it dries out properly. Water may be getting into the hull timbers, but not showing on the inside, and could lead to rot.

    If you want to maintain the history and patina probably best kept as a display model only.
  2. ChrisFBronze
    Vice Admiral
    The paint looks to be quite thick and given the extent of the cracking you need to take most if not all of it off otherwise the problem could reoccur before too long.

    As it's timber you could use paint stripper though the modern versions don't appear to be as effective. Otherwise start off with a coarse grit until you remove the layers of gloss and then take it easy. If the primer/undercoat is sound then you could repaint from there (undercoat first) after a finer sanding. If not sound, sand all the way back to bare wood. If it is plank on frame it would be a good idea to use lightweight cloth and say Eze-Kote to provide a stable base for painting.

    You need to start getting that paint off though first so that the situation can be assessed.
    Liked by DWBrinkman and chugalone100 and
  3. DWBrinkmanBronze
    Rear Admiral
    Sharp looking boat!
    I hope you find a solution to the paint problem.
    It isn't probably the easiest, but I think I'd try to strip/sand it down to wood and repaint. Then you know what you have .... But, that's just me.
    Dave B
    Liked by chugalone100 and Ronald and
  4. Ronald
    Fleet Admiral
    @Stephen T

    Stephen, your earlier posting said this model was from the 1950’s. Am I correct?

    If so, the paint would be oil based is my best guess. Do you have a reliable paint retailer in your area where you could bring the model?

    I would not recommend trying to repair it without some professional advice.

    Ron
    Liked by DWBrinkman and hermank
  5. Stephen TBronze
    Captain
    the cracking of the paint is getting worse whats the best thing to with rub it back trouble is I am not sure what its been painted with its a plank on frame construction any ideas
    Liked by hermank
  6. Stephen TBronze
    Captain
    one problem is with this boat the paint is crazing the boats a wood construction bit painted in I don't know any ideas what to do
    Liked by hermank
  7. Stephen TBronze
    Captain
    Well today soon after this photo was taken the old Robie 8.4 motor went out so I have replaced it with a 600 motor and 12v, not a fan of brushless motors
    Liked by chugalone100 and hermank and

Delete this post?

It will be removed from the site.

Discard this draft?

Your draft will be deleted and cannot be recovered.

You have an unfinished draft

What would you like to do with it?