Just needed to put a short video of one of the fellows in the club that almost sank his model .

My Model Boat club put on a show two weeks ago and videoed Harley Quinn with my iPhone which is kind of difficult while running the boat because the pusher boats were being run by the kids and I had to avoid them.

" Sea Rover " - Model of the "Sea Queen" which was the 1961 Off shore Power Boat race winner. - Listen to full narration from Buxton Model Boat Club member Dave Cole.

Working on this idea for a bit more refinement on the exhaust smoke idea. Graham mentioned these timers were worth a look, so I purchased a few from Ali Express for about 90c each. They work well for an off/on set-up but not quite as well for an on/off set-up. They are variable from 0-12 secs and have a lot of possible uses. I was trying for a puff of smoke at start-up (which in my application works in conjunction with the twin sound units (HSL and ST) and this initial test seems to work ok (bit of refinement with timing and air pump speed required yet). Already have the smoke going well but there's always a little morsel to add (ref Mr Creosote)

I'll be using the small 5A voltage regulating bucks in the models (the ones shown are just for testing) with one 2s LiPo running 2 regs,- one for pump, and one through the timer for the smoke pen. You can see the timer working with no input from the TX in the vid, When fitted, both will be switched on/off simultaneously with the solenoid 'latching' power on/off, circuit (thanks to Graham for the layout) using the left stick.
JB

my fleet, think i need a bigger pool happy with the lights and now the proud owner of an aziz will post pics of it later .smit rusland Southampton little tug ,yewgarth ,fairmount alpine ,pacific brigand, pilot boat all tested and running very well

Piper2 is another free lance design from Buxton Model Club Member Dean Ratcliffe. Piper2 is a Car Ferry /Landing Craft.
Audio commentary from Dean.

More photos in Model Boats Website - https://model-boats.com/
- "Boat Clubs & Lakes" - "Buxton Model Boat Club"

"Juno" is Bunkers Tanker, another free lance design from Buxton Model Club Member Dean Ratcliffe. Audio commentary from Dean.
More photos in Model Boats Website - https://model-boats.com/
- "Boat Clubs & Lakes" - "Buxton Model Boat Club"

Miss Sophie is a Freelance design " Motor Tug " built by Buxton Model Boat Club Member Dean Ratcliffe. Audio commentary from Dean.

More photos in Model Boats Website - https://model-boats.com/
- "Boat Clubs & Lakes" - "Buxton Model Boat Club"

Broadsword was a Herring Drifter / Armed Trawler from Buxton Model Club Member Dave Cole.
Audio commentary from Dave.

More photos in "Model Boats Website" - "Boat Clubs & Lakes" - "Buxton Model Boat Club"

💡Scratch built from plans. Plank on frame. Large brushless motor,150 amp esc,length is54 inches custom made propshaft ballraced at each end and middle. Has running lights,and large very bright searchlight. Flack Mats were made by better Half. Everything else was scratch built by myself.

RC Sailing :- Thames Barge - Sail Colours ?

A visual aid to just help decide on possible colour scheme for your Thames Barge .

" Elsa ", is a steam dredge barge built by Buxton Model Boat Club member Dean Ratcliffe.
She is roughly 1.24 scale, approximately 43 inches by 8 inches and is made from recycled and up cycled materials wherever possible. She has a single rudder and propeller, powered by a single motor from a drill, and two 6v lead acid batteries. She is a totally freelance design.