#5952

ToraDog United States Basic

Commodore  · 4,741 pts Union, Pennsylvania, United States Member since Aug 2020 Last online 8 hours ago

ToraDog’s harbour

6 boats

ToraDog’s build blogs

3 blogs

Followers

6 followers

Recent uploads

Latest activity

Last posted 11 hours ago
Blog reply Launching cradle To answer questions about launching the "beast", here are some pictures of the transporter. A Chevrolet extended van. The cradle consists of an 8 foot, roughly… 15 Blog reply Juneau floats Trials. Kicks up her heals nicely, but turns like barge. Twin screws and single rudder will do that. 15 Forum reply Re: Rescue Equipment @chugalone100 Perhaps one should "drain the swamp" before launching.... 7 Blog reply Re: build blog @JohnAsklar John, not know what kind of battery you have on board, many chargers will not bring a DEAD battery back to life. I have had my SLA chargers tell me… 3 Blog reply Re: build blog I was taught a long time ago to start at the battery when trouble shooting electrical issues. Have you measured the battery's voltage? Its there a fuse in your… 3 Forum reply Re: Binding an RX to TX (Tamco) @EricMB Eric, I do not see a model # and nothing comes up, on-line, in reference to what you suggested. How old is this unit? Have you tried binding as I sugge… 1 Forum reply Re: Binding an RX to TX (Tamco) On another forum, Modelboatbits is said to be very helpful with those radios. You may try calling them. https://www.modelboatbits.com/ 1 Forum reply Re: Binding an RX to TX (Tamco) @EricMB Which transmitter do you have, model number? 1 Forum reply Re: Binding an RX to TX (Tamco) @EricMB The internet says, 1) make sure that the receiver and x-mitter are at least 70 cm apart. I have found this to be the case with other brands as well. 2)… 1 Forum reply Re: Fuse for 12 pole 12-24 volt Hi Torque Motor (as supplied by Mobile Marine Models) @merchant67 The fuse is going to depend upon the current draw of the motor. That will be determined by the motor windings, the weight of the model, whether the… 1

Delete this post?

It will be removed from the site.

Discard this draft?

Your draft will be deleted and cannot be recovered.

You have an unfinished draft

What would you like to do with it?