… here 'bits' were needed. The smaller 'Minx' is powered by a brushless Turnigy Aerodrive SK286. The 'Wavemaster' has a brushless KD Thumrun 2387/18 and an EZ Run 18a ESC - supplied by Giantcod. First runs at Crealy - 29th July. Thanks to Ian …

… e site. I have a 34" Aerokits fire tender and use a 28 size brushless motor with Lipo battery, 11.1v 30mm 3 blade brass prop, all up weight approx 4lb. Being a small boat (relatively) weight will be your major obstacle. My model really moto …

The motor (XYH42-50 700kv 41A Brushless outrunner) bought from, Giant Cod has been installed as well as the prop shaft and aligned. I have also loosely mounted the ESC (Hobbywing Seaking 60A) and connected the water cooling tubes to and fro …

… tch built from My Hobbystore plans and Model Boat magazine, brushless motors running on 2x7.2 volt 3700 mAh batteries

… t restoring in 2010 with single Turnigy H600 1100 Kv 3.2 kw brushless with 12 Volt cell pack. Planes effortlessly and now has longer battery life than previous brushed set up (Motor: Turnigy H600) (ESC: Seawing 120 Amp) (10/10)

… r belt drive brushed motor systems or www.teamnovak.com for brushless motors. Regards, John

Found beached on e-bay and refurbished. Brushless motor running on 8.4 v. with Planet T5 2.4ghz radio. First trial at Goodrington, Paignton. 12 Mar 2010

… . Worked ok but nothing spectacular. Recently ventured into brushless and LiPo. Tried an inrunner but ran far to hot and not veryt fast. Changed to an Outrunner (mork torky apparently) and nearly took off! (it is a seaplane tender but shoul …

… s after some slow speed control that I did not get with the brushless It was stop or go and as Its a small boat you need to sale In sheltered pools and It was just uncontrollable I have moved the batteries forward as well. I could not get t …

… ut before I had chance to take a snap on water. Anyone used brushless motors In one of these? I use one In my crash tender and am thinking two In this model will go well. Blackpool next weekend so hopefully I can find out more Info on the m …

… ut before I had chance to take a snap on water. Anyone used brushless motors in one of these? I use one in my crash tender and am thinking two in this model will go well. Blackpool next weekend so hopefully I can find out more info on the m …

I have fitted an outrunner brushless motor to my model. I have tried using a 3 blade brass prop but the speed Is still too fast. I have added extra lead to the front compartment but the boat Is still almost flying. Has anyone had a similar …

… s fast, but not as fast as my seaplane tender so I am going brushless............

… ollers, but wouldn't reverse. So I bought a Tekmodel RC car brushless motor 60A ESC & program card $15. The 3480 was too fast and little tork but the 3850 works fine. Pictures attached of the internal set up. I bought a 11.1v LiPo for Steve …

I have fitted an outrunner brushless motor to my model. I have tried using a 3 blade brass prop but the speed is still too fast. I have added extra lead to the front compartment but the boat is still almost flying. Has anyone had a similar …

… her the parts to put a replacement Sea Hornet together. The brushless motor and ESC has been 'donated' from one of my 1/10th cars rather than go to a diesel... I've got a suitable prop tube and prop (Mr Harbor Models is AMAZI …