John called this model "Nancy Dancer". it started of with plans from 'Nexus Plans Service' for Vic Smeed's 'Vivacity'. John used the hull only plans and created everything else himself. it ended up LOA 49" with a beam of 17". With the 12VDC battery the weight came to 23 1/2#.

Because of his basic 'Sedan Cruiser' he designed all the mechanicals and electricals beneath the main cabin floor, including the battery. There was quite a bit of detail put into the main cabin - unfortunately not shown in the photos - including a galley, eating area, furniture and the helmsman's station. The scale is 1" = 1ft.

This hull is plank on frame using 1/8" pine planks. Below the waterline there's epoxy & glass and above there is just epoxy. All the brightwork, cabin housing & decks is natural Cherry with a clear urethane finish.

The power is a Dumas 12VDC motor with a mechanical speed control. The bottom photo shows that he added a 2:1 gearbox to the motor and ran it in reverse to increase the prop RPMs. He also included a constant running fan to cool the motor due to the confinement of the space.

The single propellor is 2" - 2 pitch - 3 bladed bronze. As on all his models he used a 2 channel JR XR2 75 mhz.

These pictures are of a scale model of Captain Joshua Slocum's "Spray". it was sailed around the world, singlehanded between 1895-1898. Slocum re-built a Delaware oysterman hull in Fairhaven, MA and had been a gift to him.

After reading of his exploits in an original copy of his book, 'Sailing Alone Around The World' 1899 The Century Co., John copied the drawings that were in the book, established a scale for each and then converted those scales to just one - 1"=14.6" and proceeded to make a model of the famous boat. At that time [2003-2004] there was a commercial kit available but after much research John concluded that he had enough information from the book to build his own version. Actually the available kit contained some mis-information about the boat and that settled the matter.

The model was built plank-on-frame and then covered with epoxy/glass since it was intended for RC. He sailed her during the summer of 2004 and was quite pleased with her performance. An opportunity to sell the model came to him and he did so in January 2005.