Building from plan going to run on a Johnson 600 powered by a 3 cell lipo with a 10" shaft & 42mm propeller it will be going to a pal in Scotland when it is finished
Aquired as response to grandsons'Can't we have one like that' request on seeing other club members ' Hooligan boat'.
Cheap second hand commercial speed boat steered by shutting down port or starboard motors and only on/off on pretend transmitter.
Now modified with proper ESC, 2.4 radio with servo operated rudder and upgraded to take 8.4v NiCad.
Length: 30 inches_ Not yet sailed in modified form !
Looks like a nice mod on her. I have one but wasn't happy with it as it didn't have a very good radio range. But did go quite well in the radio range she had. That should be a lot better now you have done this to her. I gave my brother one that I got from a boot fair that cost me a £5er. He ripped out the insides and has fitted it with a small brushless motor and 2.4gh radio and it is not so much a hooligan but more of a total maniac. But good fun.
Started 1 Oct 2014. Designed by Bennett to take an action man figure. I decided to use a drawing manikin. First try was without manikin and a great success. Still working on it to get Manakin rowing properly. 8Th feb tested and a sucsess but does not like strong wind.
Designed by Vic Smeed in 1964 for the Magazine, Model Maker. Plan No. MM812. Found plans for free on internet and decided to build it as I did not have a vintage motor boat in my collection. Did not like the cabin so redesigned it. Powered by a Johnson 600 motor,2 * 7.2v 3300 mAh battery, 20 amp Mtroniks Viper Marine Controller and a 45mm dia course 2 bladed propeller. Goes really well.
Fitted trim tabs which finished the boats performance. Tested in rough weather and got 20 mins running on a fully charged battery.
Hello, I found this old kit and I'm building, they were so many years that I did not do modeling and I'm just having fun with this nice little boat.
My kit is marked "Vladika Model", but is also produced by Aeronaut, having no patterns or instructions I have relied on the aeronaut, found (in German sob...) on the internet, and looking the photo on the box.
On the box it says it works with a Speed400 reduced 3: 1 with a (bad) 3 propeller blades 40mm, but I put a simple speed 600 20T with a 4-bladed propeller brass 45mm bought on ebay in singapore
Won this through a Marine Modeller's competition, in 2011 I think. Turned out to be solid ready to run boat, ESC threw its hand in though, but took opportunity to replace it and update receiver to 2.4Ghz. Taken a few hard knocks but apart from minor damage to railings still going strong. You May want to turn volume down as ducks and geese were in full song whilst sailing her at Ethrow Park :-)
HI heres my thunder tiger ATLANTIC POWER BOAT, with a water cooled brushless motor & ESC,dose 25 miles plus had it 12 months still flys named it annie after my wife, I all so have a saint tropez cruiser. 😀
Fighting Cock was one of the fleet of North West Tugs (Liverpool Screw Towing and Lighterage Company) steam tugs, built by Cammell Laird in 1953. The model is built on a Kingston Mouldings Sun tug hull, the superstructure is scratchbuilt from styrene, with many fittings from Mobile Marine Models. The motor was 'rescued' from a mainframe computer data drive, and is direct drive to the propeller. Power is from 12V gell cell batteries with a speed control by EA Electronics. Both hull and motor were given to my father many many years ago, and the model was completed approx 7 years ago.
Greetings from Hollywood, California. 😎 Many thanks to David Metcalf at Metcalf Moldings for his advice and for so graciously replacing parts I messed up. This craft has been swimming pool tested (after all we're in Hollywood) and it ran beautifully. Next stop is the local pond. I chose brass counter-rotating props. Those are lithium batteries tucked under the sides. I chose to recut the decks out of wood. Brits rave about plastic but I found it difficult to cut and forget about sanding down the edges. (I guess if you cut it properly you don't need to sand the edge.) Major mistake: watching a You Tube video that told me I should make brass joints using a Propane torch. it will make a good joint but it MELTS ALL THE OTHERS. There was a lot of learning here for me and thanks to David's fine kit I think I'm somewhat of a better model builder.
Nice model, very neat electrics, well done.
How come an American builds and English lifeboat?
By the way its contra- rotating props, but if you have a swimming pool as a test tank you must take some criticism, its OK I am only jealous.
My first attempt at a model boat was a scratch built Rother
at one inch and a quarter to the foot, a big buggar and heavy it had a car battery for power and ballast.
Cheers
Max 4clubs
This tug was made from a Tito NerI tug kit and modified to make it look more like one of the local tugs near my home, she is fitted with two azimuthing propellor units driven by 900 size motors and a bow thruster unit
💀 Hello friends, I am sharing a kit that sells here in Brazil. This is a fishing boat, a motor included in the kit 380 brushed, propeller shaft, pipes, all made of balsa. To put my touch to the lighting, did the radio antenna, put some flags. Detail is left with the box of fish that are rice painted with spray paint aluminum.
My own design deep "V" hull with upper-works loosely to 1:15 scale replica of the Mitchell 31 boats previously used by various Hampshire constabularies in and around the Solent. The intention is to fit this model with a working, rotating, radar scanner using the servo motor and gearbox from an old video camera lens system; working lights including flashing blue police lights and a sound-alike "wee-wah" siren - just for the hell of it (and because I can)! Technical details: Hull length: 867mm. Construction: GRP layup with 1.5 and 3mm ply and balsa deck, cabin etc. Motor: MFA Torpedo 850. Propeller: X50mm plastic. Battery: 2 x three cell LiPo pack in parallel. Speed controller: Mtroniks Viper 25Amp. Radio: Hobby King 2.4GHz.
My son says this is way off a replica of the Solent police launches of that time: a) it moves too fast, b) it's not billowing black smoke, c) it's not making enough engine noise, and d) it's not towing half the Solent behind! 😀
