Photos & videos

Sign in to share

Search results

3 posts
chrys
Leading Seaman
1 / 2
KATE. pilot boat
pilot boat, made from kauri strip planks and then glassed.bowsprit slides in for transport and mast comes out.
Small motor to get you home if no wind.
Liked by Baggie and figtree7nts and
4 comments
  • muddySub-Lieutenant
    Hello, Many Thanks for info.. appreciated.
    Regards Muddy
    Liked by fireboat
  • brdlilleRecruit
    Hello! I like the pilot boat !
    Liked by Inkoust
hammer
Lieutenant
1 / 4
HILDA
Another damaged fiberglass hull rescued. every thing else made by me. At 3/4"=1' a very big model. Completed 2012 but only sailed twice, a very good sailor just needs a big lake. The mast lifts & folds forward after removing the hatch. The top mast lowered, the bowsprit retracted and the sails raped around the shrouds, held in place with masking tape. ( this stops the lines from tangling.) Takes about 5 minutes to reassemble.
Chiefpurser
Leading Seaman
1 / 4
Stardust
HI fellow model leers.this is my latest model.Built in 1926' for the Ffyfe(bananas) family. Originally it was run on steam,but in 1939 converted to diesel,this was kept until 1957 when all the staterooms were replaced by cargo holds . She was then made into a feeder bringing eleven thousand boxes from Rotterdam to Southampton. She was scrapped in the seventies.my model of her was from 1926 the scale is approx 1/30th her length is 48 inches including bowsprit, and has a beam of 10 inch amidships. She is totally scratch built, plank on frame, all the decks are individually planked with black card in between , wheel house and all other parts are mahogany. She runs on a decaperm geared motor @ 6 volts, and the lighting system consists of 10 accommodation lights, port and starboard , wheelhouse, and both mast headlights,the large saloon skylight is also lit up with a set of disco lights on a separate circuit. The funnel houses a heavy duty smoke unit switched on by switching unit.
2 comments
  • seafarerPetty Officer 1st Class
    💭 Hi Chiefpurser, Stardust looks really good, did you have problems with buoyancy, and how much does it weigh, how do you transport and launch such a big model?
    Looks a good pool, where do you sale?
    Liked by Brightwork
  • ChiefpurserLeading Seaman
    HI thanks for the comments. No problems with buoyancy only 6oz lead to bring her upright, a bit tender but will be adding a further 16 oz of ballast before next outing. She will weigh 18 lbs. transport is not a problem back seat of the car. Lifting and lowering into lake with two strops. This is not really a big model. I have one at 58 inches. We sail in several locations in Scarborough, North Yorkshire. My next model is already on the stocks and will be a jet boat a bit like a super doper cabin cruiser, own design and scratch built as per stardust. Regards jim

Liked by

Loading…

Delete this post?

It will be removed from the site.

Discard this draft?

Your draft will be deleted and cannot be recovered.

You have an unfinished draft

What would you like to do with it?