Chris Craft Riva
Building a Chris craft Riva from scratch seemed a good idea.. I use three ply scrap wood costing three euros fifty cents so far.But I have in stock rolls of two inch wide veneer which I wrap around the stringers. So far it's three thicknesses thick which I feel is enough. Next stage is a hard sanding then a varnish before the 100 and things to do to it.
Any comments appreciated and ideas.
Alan

Model kit made on or about 1969 by defunct German firm Robbe based upon Chris Craft Roamer motor yachts of the era. Hull appears to be inspired on 1950s Chris Craft Constellation series. Model tried to emulate a 46 feet version. I got this one half-built and adapted as a gift for my child inspired in the "My Little Pony" characters. Approx. 1/20 scale. Authentic Chris Craft Roamer 46 measured 46 x 15 feet. it runs with a 4-bladed 40mm metal propeller, 320A 7.2V-16V ESC 30A constant, a NiMH 9.6v battery, and a Mabuchi 540 Motor.

22.5 inches RC boat inspired on 1970s Chris-Craft Commander 36, 42 and 45 footer boats. Model equivalent to a real-life 36 footer vessel. Barebones fiberglass hull from a UK manufacturer. Powered with a brushed 500 motor, 30A controller, 9.6v NIHM battery. Video made during first trial at the Eibsee lake in Bavaria, Germany.

Hi all.

Some shots of my scratchbuilt 42" Sterling ChrisCraft Corvette.

Twin brushless on 2 X 3S 5000 lipo.

Have nice day / Ivan

The hull of this model was my own design in 2004 and was sailed for 2 years, and then a new upper decks and battery system were added during the winter of 2005. The hull performed well enough but my original cabin design was too crude to keep.

The boat shown here depicts my effort to copy a 1958 ChrisCraft Cabin Cruiser at a scale of 1" = 1'.

The hull is 1/8" thick pine planks on frames with hand cut Walnut decking and 3/16" Walnut cabin sides. No epoxy or glass was used on the hull - just a good paint job.

The big change was to replace a bulky & heavy 12VDC leac acid battery with 9 AA dry cells connected in series. Bathtub testing indicated I could expect about 2 hours running time at full speed and that estimate was about right. A Dumas 12VDC motor and mechanical speed control were used with a JR XR 2 control.

The reduction in battery weight made a very large speed and appearance difference. Availability of the AA cells was an economic plus.