For my first foray into boats I have acquired what is like a Vosper Firefloat Mk.2 but it is different. The wheel house section of my boat is different, being longer, the mid-ship section having three windows in lieu of two and the stern is completely different in profile.

I have spent many nights trawling the internet to see if there is anything like my very detailed model but to no avail and I have even asked a few of my old work colleagues who are ex-naval men if they can help out in identification. I am wondering whether this could be an elusive Mk. 1 - the boat that was never put into commission.

I attach a few photos of my model in the hope that someone out there can throw some light on it. it is in very good condition and a few years old, is fitted with a Graupner Eco 600 motor on a single prop with 7.2 NiMh batteries. it is about 34" in length and 9" beam and goes really well, planes quickly and turns very tightly - in all a cracking boat. The numbers on the side of the boat are strange as they relate to what I believe is a coastal command unit - the numbers are not new as they appear to be original under the paintwork. Any help in identifying what actual boat it is modelled on would be appreciated.

Regards
Alan

My restored Aerokits Sea Queen with Brushless motor at Fleetwood on a very windy day

Photo's taken on sunday [6/4/10] weather was quite windy so water a bit choppy, but fireboat coped very well as you can see from the superb bow wave it creates! the twin prop and 4 rudder arrangement makes it a very maneouverable boat, even at high speed it handles all tight turns with ease and dont swamp the stern deck either!

Had a full refurb but still need the window frames making when I can get round to it . Goes really well with a Graupner 700BB Neodym on 14.4 volts. Still trying to find the right prop, but pretty close now to getting it right . Aim to getting it up to 19.2 volt
Should really fly then.

Almost finished now, just the windows and transfers to do.

It runs well.

This model was built from scratch except for the fiberglass hull, using styrene. The drives are Graupner VSD's and the 10 fire monitors are powered by BMW windshield washer pumps. The radio is a Spektrum DH 6 with a twin stick modification and fitted with a switch 8 to individually operate the monitors.

LCT 247 built from scratch by some one ?

Bought off Ebay, it runs on 7.2volt with a johnson 565 motor. Go's like the wind.

More of the Crash boat at our sea water creek and of Peter Dimberline taking a rest after an exhausting day at the radio sticks steering the model. After all, I only did the car loading, driving to the site, carrying fueling and starting, entry to the water and launching and taking the model out of the pond , cleaning and refueling etc to go again. You can see Peter is getting his stamina back. I only ever used 3;1 fuel and in later years 4;1 fuel, just how fast do you want to go? and I have defeated that(annoying) high whine of model engines with my muffler system. Needle valve is left alone and two or three clicks turn out/in in Summer or Winter is of no consequence, maybe too many fiddlers with model engines breaks down reliability? I usually wind the plug out 1 to 2 turns and start her dry and with one or two turns (electric starter belt now) of the flywheel and a fraction choke she STARTS at a bit above idle setting on carby , then throttle to idle disconnect plug lead and then screw in glo plug and lift model casually to pond and slowly place in water at IDLE. Just a bit of a mild throttle check / rudder function check, water outlet check, LOOK AHEAD and if safe clear release and gently open up.